MISC

Best Arduino Gps Modules 2020 | Reviews of Best Arduino Gps Modules

Hello, Are You looking for a Best Arduino Gps Modules?, Then you a at right place. Read this article and you will get right option for Best Arduino Gps Modules.
Because we have spent 10 Days for Finding List of Best Arduino Gps Modules of 2020, which has amazing features.

This is the best Best Arduino Gps Modules available in the market today. So, go through this article you will get best Best Arduino Gps Modules.

Top 10 Best Best Arduino Gps Modules 2020

Top 10 Best Best Arduino Gps Modules 2020

DIYmall 6M GPS Module with EEPROM for MWC/AeroQuad with Antenna for Arduino Flight Control Aircraft

 in stock
1 new from $17.99
Free shipping
as of September 25, 2020 1:58 am

Features

  • When you test the GPS module, pls kindly note that you need test it in outdoor wide plain place, not indoor.
  • Document link: https://engineersportal.com/blog/2018/5/9/comparing-iphone-gps-against-neo-6m-gy-gps6m-gps-module-with-arduino
  • Youtube link: https://www.youtube.com/watch?v=VziqwqLaGso
  • LED signal indicator,With data backup battery
  • EEPROM power down to save the configuration parameters data

BN-220 Dual GPS Glonass Module Navigation TTL Level 9600bps + GPS Passive Antenna for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Flight Control Geekstory

 in stock
1 new from $15.99
Free shipping
as of September 25, 2020 1:58 am

Features

  • BN-220 has flash to save configuration, so you do not need to reset data next time when you use it. But it has no compass. If you need gps with flash and compass, please buy bn-880 from Geekstory.
  • When you use it for Raspberry Pi, there is no driver needed but you need to install software
  • The TX LED flash means gps module output normally.The PPS LED flash means gps module locate your place.
  • Data Level : TTL or RS-232,Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
  • Document link: https://youtu.be/IZQRBHrH8Qk. If you have any issue when using our product,or you need product use documentation, please contact us directly for assistance. We will reply your problem in 24 hours.

Gowoops GPS Module with 3m Active Antenna for Arduino STM32 51 Single Chip Microcomputer

 in stock
1 new from $25.99
1 used from $14.63
Free shipping
as of September 25, 2020 1:58 am

Features

  • 1. With micro USB port, you can use general mobile phone cable to connect the GPS module to your computer. Do not need USB-TTL, convenien for use.
  • 2. The GPS module has ceramic passive antenna, you can search the satelite in a open area, do not need the external antenna.
  • 3. With SMA port, convenient for connect with the 3m Active Antenna, stronger satelite search ability.
  • 4. With the reserved TTL port, covenient for connect to USB-TTL or external single chip microcomputer.

ACROBOTIC NEO-6M GPS Module Breakout Board for Arduino Raspberry Pi ESP8266 NEO6MV2 GY-NEO6MV2 Serial UART TTL 3~5VDC

 in stock
1 new from $14.49
Free shipping
as of September 25, 2020 1:58 am

Features

  • The NEO-6 module series is a family of stand-alone GPS receivers featuring the high performance u-blox 6 positioning engine
  • Serial UART digital-output of GPS data (UART TTL, 9600bps)
  • The 50-channel u-blox 6 positioning engine boasts a Time-To-First-Fix (TTFF) of under 1 second. Power Supply: 3.3~5VDC (onboard low dropout regulator)
  • Compatible with various flight controller boards designed to work with a GPS module, e.g., APM2.0 and APM2.5
  • Documentation, tutorials, demos: https://youtube.com/acrobotic

BN-880 GPS Module U8 with Flash HMC5883 Compass + GPS Active Antenna Support GPS Glonass Beidou Car Navigation for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller Geekstory

 in stock
1 new from $18.19
Free shipping
as of September 25, 2020 1:58 am

Features

  • BN-880 is suitable for Open source flight controller, not for flight control with SCM
  • It is dual module compass, with and electronic compass IC HMC5883L
  • This gps module has flash to save configuration. So you do not need to reset next time when you use it
  • DIts data Level is TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
  • When you use it for Raspberry Pi, there is no driver needed but you need to install software

MakerFocus LoRa GPS Module LoRaWAN 868 915mHz Development Board LoRa Kit Ultra Low Power Design CP2102 SX1262 ASR6502 Chip with 0.96 inch OLED Display and Antenna for Arduino and Intelligent Scene

 in stock
1 new from $28.99
Free shipping
as of September 25, 2020 1:58 am

Features

  • User Manual: https://drive.google.com/file/d/1UBGTCADqxRDXKX18tMvtdBzNyBXQLSDL/view?usp=sharing
  • Ultra Low Power Design and Application: 50uA in deep sleep; Compatible with Arduino, AT command and GPS, Integrated encryption algorithm.
  • IoT Board: Based on ASR6052, those chips are already integrated the MCU and SX1262.
  • Onboard Solar Energy management System and Lithium Battery Management System: It can directly connect with a 5.5~7V solar panel; Onboard SH1.25-2 battery interface, charge and discharge management, overcharge protection, battery power detection, USB / battery power automatic switching.
  • OLED Display Screen: Onboard 0.96-inch 128*64 dot matrix OLED display, which can be used to display debugging information, battery power, and other information.

Gowoops GPS Module with TTL Ceramic Passive Antenna for Arduino Raspberry Pi 2 3 B+ MCU

 in stock
1 new from $20.99
Free shipping
as of September 25, 2020 1:58 am

Features

  • This is a small size item, and it has excellent performance. This item has data backup battery and LED signal indicator.
  • Comes with 25 x 25mm ceramic passive antenna, strong star search ability.
  • Various parameters can be set via the serial port, and can be stored in the EEPROM, easy to use.
  • Compatible with 3.3V / 5V level, convenient for connection to a variety of microprocessor systems.
  • Built-in rechargeable backup battery, you can keep the ephemeris data when power down.

MakerFocus GPS Module, GSM GPRS GPS Module 3 in 1 Quad Band GSM/GPRS IPEX Antenna DC 5-9V Support Voice Short Message for Arduino STM32 51 Microcontroller MCU

 in stock
1 new from $16.99
Free shipping
as of September 25, 2020 1:58 am

Features

  • Detailed connection info has been provided as the picture shown. Download the material from ★ ★★ ★★ https://drive.google.com/file/d/138HQ3I44rRoVnPL7591B78pNOI94gK9x/view?usp=sharing
  • IPEX interface active antenna; Two-stage amplification, high gain, strong signal. Support voice SMS GPRS, support GPS positioning. Insert the SIM card and Arduino board, you can send voice and short message to other SIM cards. User can browse webpage via GPRS after connecting to the LCD and get the GPS info of the module .
  • Support Quad Band: 850MHz / 900MHz / 1800MHz / 1900MHZ With 1pcs of 3m GPS antenna and 1pcs of 2m GSM/GPRS antenna which support more stronger and stable signal .
  • User can browse webpage via GPRS after connecting to the LCD and get the GPS info of the module.
  • We a Strong After-sales Service Team: As long as you have any questions about the product, we will resolve your issue immediately if received your email, your satisfactory purchase experience is our greatest hope! How to email us? Plz click “MakerFocus” and click “Ask a question” to email us! Looking forward to your consultation!

Geekstory 4G GPS GSM GPRS Module SIM7100A Development Board 5-18V LTE WCDMA GNSS B2 B4 B15 + GPS Antenna for Arduino Raspberry Pi Window Linux

 out of stock
as of September 25, 2020 1:58 am

Features

  • SIMCom presents an ultra compact and reliable wireless module SIM7100A which is based on Qualcomm MDM9215 multiple-mode LTE platform.
  • SIM7100A is a complete multi-band LTE /WCDMA/GNSS module designed with very powerful processors integrating application core. Document link,http://blog.diymalls.com/2018/02/24/sim7100a-4g-development-board-for-arduino-raspberry-pi-diymall/
  • If you want to make it work over UART, please use one FT232 USB to Serial Adapter Module, not the uart port on this board.
  • It supports quad-Band LTE-FDD B2/B4/B5/B17, and dual-Band UMTS/HSDPA/HSPA+ B2/B5
  • Download document link: http://www.diymalls.com/files/FZ2846-US-sim7100A-board-4G.zip (If you need User name and Password, please contact me)

SIM808 Module GSM GPRS GPS Development Board + IPX SMA GSM GPS Antenna Support 2G Network for Arduino Raspberry Pi Geekstory

 in stock
1 new from $21.19
Free shipping
as of September 25, 2020 1:58 am

Features

  • Document link,https://tinyurl.com/yykfnn7c ,This SIM808 module only works with 2G Network It can send SMS message. If your place is 3G Network, pls buy sim5320a Module. If you need 4G module, pls search SIM7100A in my store.
  • It is used to open / close the input power supply for the module. When in use, please confirm the toggle switched to the OPEN state (near the board inside)
  • SMA antenna interface: there is a GSM antenna interface, a GPS antenna interface onboard and a BT antenna interface
  • USB interface: This interface is just use to update the firmware of SIM808 module
  • If you have any issue when using our product,or you need product use documentation, please contact us directly for assistance.we will reply your problem in 24 hours.We try our best to provide the most professional service for each customer.